Bend the wire and close up the little green plug from the big ATX plug to any other BLACK plug. Cause the black is the ground. To come off best you should connect the green with black besides the green. Your PSU should power up immendiatly!Estimated Reading Time: 2 mins. · So the only thing it could be is either the motherboard or power supply. It would be easy to find out if we had some spare parts I could swap out but we don't, so anyway does anyone know how to start up an ATX power supply manually. I've seen some stuff online about shorting pin 14 on the main connector (the one with the green wire) with any. · Method #1: A piece of wire Wire Stripper / Knife.
Its not the switch (I've swapped the reset and power buttons to check that already) So the only thing it could be is either the motherboard or power supply. It would be easy to find out if we had some spare parts I could swap out but we don't, so anyway does anyone know how to start up an ATX power supply manually. Method #1: A piece of wire Wire Stripper / Knife. A short video on how to jump start a power supply using a paper clip!*****WARNING! follow the instructions at your own risk. OverclockersClub cannot be h.
31 thg 7, Storage Humidity 5% – 95%. Safety Instructions: Install according to the manufacturer instructions; Do not open the power supply case or attempt. If your computer experiences Blue Screen of Death crashes, hard drive errors, or just plain won't boot, you may be dealing with a faulty power supply. You will need a paper clip or a PSU jumper to perform this test. IMPORTANT: Make sure that you jump the correct pins when testing your PSU. Jumping the.
0コメント